SCIA-RID

 

Unit of packaging

Steinernema spp. (insect-parasitic nematode)

SCIA-RID pack size: 8 blisters in a box

Contains: 8 x 50 million larvae (third stage) in inert carrying material

Large SCIA-RID (2 x 250 m) pack size: 2 bags in a box

Contains: 2 x 250 million larvae (third stage) in inert carrying material

 

Quantity to be used

• SCIARID (8 blisters @ 50 million): use 1 blister of 50 million nematodes for 33 m2
• Large SCIA-RID (2 bags @ 250 million): use 1 bag of 250 million nematodes on 165 m2

 

Preparation of solution

• put the contents of the package into a bucket containing 5 litres of water (15-20°C/59-68°F)
• stir well and leave the solution to soak for 20-30 seconds
• stir well again and pour the entire content into spray tank
• fill up with the required amount of water (minimum 1 litre per m² of mushroom bed)
• spray immediately after preparation
• use the whole package at once, the distribution of nematodes in the pack is not homogenous!

 

Target

Larvae of mushroom / sciarid flies. Some effect on other species of flies (f.e. Phorid flies).

 

Rates
SCIA-RID	rate	m²/unit	interval (days)	frequency	remark
preventive	1.500.000/m²	see above	7	1 - 2x	within 2 days after casing; repeat after 1 week if necessary
curative light	1.500.000/m²	see above	7	2x	within 2 days from casing
curative heavy	-	-	-	-	-

 

Application and dose

• with a watering-can, irrigation system, knapsack or motorized sprayer
• to avoid blockages all filters should be removed
• use a maximum pressure of 5 bar
• the spray nozzle opening should be at least 1/2 mm (500 micron)
• spray the solution evenly over the area to be treated when using as a post casing drench
• continuous mixing should take place to prevent nematodes sinking to the bottom of the spray tank

 

Environmental conditions

The casing should be humid and its temperature not greater than 28°C/82°F.

 

Storage and handling

• storage time: see box for expiry date
• storage temperature: 2-6°C/36-42°F
• in the dark
• remove product from insulating outer for rapid cooling of content

 

Remarks

In case of casing incorporation, use a rate of 15 million/m³ of casing material.

 

Appearance

Larvae (third stage): size 0.8-0.9 mm

Other stages: develop inside host

 

Mode of action

The nematode enters the larva of the sciarid fly via mouth, anus or respiratory openings and starts to feed. This causes specific bacteria to emerge from the intestinal tract of the nematode. These spread inside the insect and multiply very rapidly. The bacteria convert host tissue into products which can easily be taken up by the nematodes. The sciarid larva dies within a few days.

 

Visual effect

Infected insects colour yellow to (light) brown and become slimy. Hence they are difficult to observe in the substrate.

 

Important!

The introduction rates of this product should be adjusted to the mode of action of the product and the results that can be expected in the crop where the product is applied. Your local Koppert consultant or recognized distributor will be able to advise you further.

 

Only use products that are permitted in your country/state and crop. Check local registration requirements.
Koppert Biological Systems can not be held liable for unauthorized use.