ROLLERTRAP

Remarks

Before hanging up, make sure the rollertraps are at least at room temperature. Then the glue is softer and the traps will unroll easier.

Required materials for hanging up

 

Material Safety Datasheet (pdf) 

 

Roll of string

Clothes-pegs, paperclips or staples

 

Unit of packaging

ROLLERTRAP-sticky ribbon

Colour: yellow and blue

Sizes: roll of

• 15 cm x 100 m
• 5 cm x 100 m (only yellow)
• 15 cm x 500 m
• 30 cm x 100 m

 

Quantity to be used

Rollertraps are especially meant for trapping pests on places with a great pest pressure or places where a high pest pressure is expected, for example along gables, ventilation windows and places with draught. Preferably, rollertraps should be hanged when the crop is still low. In ornamental crops you can use the rollertraps basically year round, but with vegetable crops the best time is after the first planting or just before planting.

The advice is to use 1 rollertrap per 2 or 3 bays.

Depending on the pest pressure (to be expected) small or large rollertraps can be chosen.

 

Procedure

• Cut off a few pieces of string of approximately 40 cm and keep them within reach.
• Tie the loose end of the rope from the roll with a flat knot to the greenhouse pole nearby the concrete path. Do this ± 25 cm above the crop for the small rollertraps and ± 40 cm for the large rollertraps.
• Walk with the rope and unroll until the gable.
• On the way back to the concrete path fasten the long end of the rope to every greenhouse pole (or every second greenhouse pole) with the loose 40 cm-pieces of the string.
• Stab a spar (or another 'expedient') through the rollertraps roll to hold it easily.
• Take the beginning of the rollertrap and wrap it to the first greenhouse pole at the concrete path. Walk slowly with the roll to the side, through which this rolls of.
• Fold the (unglued) upper edge of the trap round the rope and fasten the rope by means of the clothes-peg, paperclip or staples.
• Make, if necessary, the sticky trap heavier with for example a clothes-peg every 2-3 meter, so that the trap will hang straight.
• Go on like this up to the gable (end) (or up to the end of the rope). Cut the trap approximately 40 cm longer than the last greenhouse pole. Wrap the end of the rope to the last greenhouse pole and fasten it to the end of the string.
• The same procedure counts if the rollertrap will be hung up along the gable.

 

Target

Yellow: trapping white fly, leaf-miner, aphid, thrips and fungus gnats

Blue: trapping thrips and fungus gnats

 

Rates
ROLLERTRAP	rate	m²/unit	interval (days)	frequency	remark
preventive	-	-	-	-	-
curative light	1/1000 m²	1000	-	-	-
curative heavy	1/500 m²	500	-	-	-

 

Remarks

Before hanging up, make sure the rollertraps are at least at room temperature. Then the glue is softer and the traps will unroll easier.

 

Required materials for hanging up

• Roll of string
• Clothes-pegs, paperclips or staples

 

Important!

The introduction rates of this product should be adjusted to the mode of action of the product and the results that can be expected in the crop where the product is applied. Your local Koppert consultant or recognized distributor will be able to advise you further.

 

Only use products that are permitted in your country / state and crop.