Anso-Mite

times Carefully sprinkle on the leaves Make sure the material remains on the leaves for at least a few hours after releasing the predatory mites Can also [...] Koppert advisor or a recognized distributor of Koppert products for advice on the best strategy for your situation. Environmental conditions Amblyseius andersoni [...] product can be stored for 1-2 days. Storage temperature 10-15°C/50-60°F. Storage conditions In the dark, provide ventilation to prevent CO 2 accumulation.

Red palm weevil

Due to the specific morphology of the palms, direct or indirect destruction of the apical bud will lead to the death of the plant, which makes the red palm [...] weevil The adults of the red palm weevil ( Rhynchophorus ferrugineus ) are typical weevils: the head extends with a long thin rostrum that holds the antennae [...] larvae migrate to the periphery of the palms to build a solid elongated cocoon made of rolled-up palm fibres. After the cocoon is formed the larva enters a

Attracker

Prepare the spray solution of the insecticide according to the user instructions on the label Shake the Attracker container well before use Add the correct [...] correct amount of Attracker to the spray solution Mix thoroughly Application Apply the plant protection product according to the user instruction of that product [...] spray solution, insects are more exposed to the product leading to increased control. Pack size 5 and 10 litre container. Formulation Soluble concentrate

Sportnem-H

brochure Preparation Remove the sachets from the box and keep them at room temperature for 30 minutes Empty the contents of the sachets into a bucket containing [...] 15-20°C/59-68°F Stir well and leave the contents to soak for five minutes Stir again and pour the contents of the bucket into the half-filled spray tank (except [...] a general rule for tank mixing, always add the nematodes to a fully filled tank containing the compatible product The product is safe for most beneficial

Swirski Ulti-Mite

in the crop, not exposed to direct sunlight Sachets already have an exit hole Hold sachets by the cardboard strip at the top, to avoid damaging the predatory [...] weeks if the pest is not controlled. Consult a Koppert advisor or a recognized distributor of Koppert products for advice on the best strategy for your situation [...] after receipt. If necessary, the product can be stored for 1-2 days. Storage temperature 10-15°C/50-59°F. Storage conditions In the dark, provide ventilation

Entonem

nematodes Preparation Remove the sachets from the box and keep them at room temperature for 30 minutes Empty the contents of the sachets into a bucket containing [...] 15-20°C/59-68°F) Stir well and leave the contents to soak for five minutes Stir again and pour the contents of the bucket into the half-filled spray tank (except [...] a general rule for tank mixing, always add the nematodes to a fully filled tank containing the compatible product The product is safe for most beneficial

Thripex-V

bran. Application Turn and shake the bottle or bucket gently before use Bottle: Push the centre of the cap to open the dosage hole Bucket: Use a spoon to [...] leaves or put small heaps on rockwool slabs Make sure the material remains on the introduction site for at least a few hours after introduction Choose at least [...] should always be adjusted to the particular situation. Start introduction as soon as the first pest mites are detected in the crop. Introduction rates typically

Natutec_Airobreez_-_Directions_for_Use_-_Koppert.pdf

is kept in the reservoir on the side of the device. The bucket ring inside the reservoir continually mixes the product. At the same time, the bucket ring [...] an amount of the product through the slide into the duct. A fan blows air through the duct. The air in the duct blows the product out of the device and across [...] come out of the device. Clean the rails on the device are clean. Clean the connectors on the battery and the device. Examine the battery for visible damage

Thripex

Bran. Application Turn and shake the bottle or bucket gently before use Bottle: Push the centre of the cap to open the dosage hole Bucket: Use a spoon to [...] leaves or put small heaps on rockwool slabs Make sure the material remains on the introduction site for at least a few hours after introduction Choose at least [...] should always be adjusted to the particular situation. Start introduction as soon as the first pest mites are detected in the crop. Introduction rates typically

Mycotal FAQ

penetrate the pest’s body cavity. Here they proliferate and destroy the tissues, killing the insect. At high humidity, the fungus then grows through the insect [...] between 7 and 10 days after the spraying application. Is Mycotal safe for the beneficial insects and pollinators in my crop? Mycotal is safe for pollinators and [...] during the day. Humidity levels must be 70%(RH) at the moment of application and a couple of hours after the application. The humidity within the leaf canopy